Light Sequencer Controller 3-Output with "teach mode"

Description: For Hobby lighting projects / animation Three Output Lighting Controller / Sequencer with "Teach Mode"Model# MICRO-3 (in Plastic PCB carrier) Manufactured by JOEZGARAGE (Assembled, programmed and tested in the USA) If you have a 3-light visual device hanging in your game room, basement, garage, etc. and would like to make it change lighting you are in the right place. Measuring only 2-1/8" X 1-7/8" (Plastic Carrier Dimensions), this board fits easily into a small space. Features: "Teach Mode" lets you teach the controller how long each step should stay lit, therefore: Y duration is not tied to R/G duration R and G timing does not have to be the same It ships with the timing preset to G=15 seconds, Y=4 seconds, R=20 seconds, however you can change these times to whatever you like. Extended cycle timing range from 1/2 second to over 20 MINUTES per teachable light/step Ultra Compact Size (Approx. 2" X 2") Screw-Terminal connections, eliminating the need for soldering 100 Watts per output channel LED compatible (120 vac) Simple TIME-SETTING procedure Wiring Diagram is Included (or you can download the PDF ) User-replaceable fuse (Type GMA 2 - 2.5A) All solid-state on-board switching electronics 120 VAC 60HZ standard voltage operation Retains timing even if power is removed OVERVIEW Each outputs timing can be set differently using "teach mode", with a possible range of 1/4 second to 20 minutes PER LIGHT. Unlike other controllers, the Y timing is not tied to the R/G times. The fuse is user replaceable. Fuse type is GMA 2A - 2.5A 125/250VAC available from any local Radio Shack or Electronic store. MOUNTING: The plastic carrier can be adhered to any flat, non-porous surface with the double sided sticky tape on bottom... Peel and stick. Every unit is fully tested before shipment. A wiring diagram is included with circuit board and/or you can download the PDF from our website. Laser Printed Wiring diagram / instruction sheet included (8.5" X 11") WARNING: Qualified electrical wiring skills for this item are required. Familiarity with 120 VAC / High Voltage is also required. Consult a qualified electrician for installation. Improper wiring of this unit can result in an electrical shock. Note: Do not connect a Dimmer, Dusk sensor, Motion sensor or other similar device to the power input of this controller. Doing so can cause erratic controller behavior and possibly damage the controller voiding the warranty. Controller / Sequencer Specifications: Operating Voltage: 108 - 120 VAC Output Channels: 3 outputs: G, Y, R Total Wattage per output channel: 100 watts @ 120VAC Teachable G Light Timing Range: From 1/2 second to 20 MINUTES Teachable Y Light Timing Range: From 1/2 second to 20 MINUTES Teachable R Light Timing Range: From 1/2 second to 20 MINUTES Setting timing (Teach Mode) overview... Using a plastic pen or similar non-conductive item, press and hold down TIME-SET button for 5 seconds until TIME-SET-LED comes on, then release button. Press and release the TIME-SET button when you want to "teach" that step's duration and advance to the next light/step. Do this for each light/step. Once the red-light timing is "taught", the TIME-SET-LED will turn off and the controller will start normal operation with the newly taught steps. note: The new time settings will remain in memory EVEN IF POWER IS REMOVED. Installation and Time Setting Instructions (PDF)

Price: 89 USD

Location: Downey, California

End Time: 2024-09-28T18:19:56.000Z

Shipping Cost: 12 USD